Adjustable Pedestal is a new type of building material imported from Europe. Its main material is high-density polypropylene. The Pedestal produced by Hangzhou  Moonbay  Industrial Co., Ltd. has high strength, aging resistance, long life and strong weather resistance. It is not affected by cold and hot moisture.

In general, the Pedestal is composed of an adjustable base and a rotatable joint, with a heightening member in between, an increase in the heightening member, and a rotation of the thread to adjust the height desired. The main accessories of the universal support are separators, gaskets and retaining rings. Today, let's take a look at how it is installed.

First, the installation notes:

        1. The adjustable pedestal is supported by the thread. Therefore, when each section is turned up and down, it must be ensured that at least 3~4 threads are engaged. Do not loosen some parts and tighten some parts.

        2. To prevent the support from shaking, after the height is adjusted, tighten the green retaining ring in the opposite direction.

Second, the fixing method: In order to prevent damage to the waterproof layer, the base of the support is poured on the ground with cement mortar, as shown below:

Third, the installation sequence:

       Put four supports and install a floor; then place two supports, then put a floor; and so on, until it is full.

       The entire pool (as shown below); must not: fix all the supports, and then uniformly spread the stone floor      (wrong).

Fourth, the pool wall, pool angle how to use the support method:

        As shown below: The top separator of the support can be cut N at will.

        2 is the pool wall (overhead 2 floors), 1 is the pool corner (overhead 1 floor).